![]() ![]() If your paste comes with an applicator, you could use this tool to spread the paste out evenly before clamping the heat sink down. This lid, also called an integrated heat spreader, is the heat sink that distributes heat from the processor to the CPU cooler. You don’t need a lot of paste: a pea-sized amount will suffice. Apply the thermal paste onto the center of the central processing unit’s lid.You can even use a little compressed air to ensure the area is dust-free before applying the thermal paste.Īfter the CPU is clean and dry, you’re ready to apply the new thermal paste. ![]() Make sure no particles of dust or other debris makes their way onto either surface, especially after you have applied thermal paste. I like to take a clean microfiber cloth at the end to remove the last bit of surface purifier that may be left to ensure the surface is dry. ![]() Make sure the CPU dries completely before you begin the process of applying the new paste. It will simplify thermal paste removal and allow for a well-prepared surface for fresh thermal paste. Thermal paste removers leave behind a residue that needs cleaning to get a truly clean surface.ĪrctiClean (Links to Amazon) ( Or Walmart) is a good cleaning kit with both. Then apply some surface purifier fluid to ensure the surface is properly prepared. Thermal paste remover is awesome and will make short work of any old dry paste. Important: Never use a scraping device of any kind to remove old thermal paste. Keep applying thermal paste remover to clean areas of the cloth and repeat the cleaning process until all the old thermal paste is completely gone. To do this, put some thermal paste remover on a microfiber cloth and rub the old thermal paste away. If you’re replacing old paste, you’ll need to remove it. How to reapply thermal pasteīefore you begin applying your paste, clean your central processing unit. In general, once every three years should be often enough to replace the thermal paste.
0 Comments
Leave a Reply. |